Daily Cleaning
37924.0001A 10/09 © 2009 Bunn-O-Matic Corporation
TCD-1 & 2 Use and Care Instructions
LIFT THE DISPENSER USING THE HANDLES ONLY. DO NOT LIFT THE DISPENSER FROM THE BOTTOM.
2. Open the faucet to re-
lieve pressure in the sys-
tem.
3. Since the bag con-
nector(s) have an internal
shut off built in, it will be
necessary to cut off mat-
ing end of a Bag In a Box.
Keep this mating end for
future cleanings of the
system.
4. Connect dispenser’s
bag connector to the cut
off mating piece the same
as you would connect to a
Bag In a Box. You should
now have an open system
thru the tube to the dis-
penser.
1. Turn handle on rear of
dispenser to shut off the
water supply.
5. Turn on water supply
to the dispenser.
6. Place bag connector
into a 1/2 gallon container
of dish soap and warm to
hot water (130° F/54° C).
7. Place a large container
under dispenser faucet.
8. Open faucet until the
soap/water mixture in the
container is empty.
9. After the soap mixture
has been flushed through
the system, fill the con-
tainer with warm to hot
tap water only (no soap)
and repeat steps 6 thru
8 until all soap has been
flushed from the system.
10. Remove the mating
end of connector and at-
tach dispenser’s connec-
tor to a Bag In a Box and
dispense several cups to
prime the concentrate line
or until consistancy of the
product is correct. If us-
ing bottled concentrate,
replace the draw tube in
the concentrate bottle.
11. Wash the entire out-
side surface of dispenser
with a clean, damp cloth.
Note: When the system
is not in use for extended
periods of time (nights,
weekends, etc.), leave the
water supply off.
If using bottled concen-
trate, place the draw tube
in the container with soap
solution.
