INSTALLATION INSTRUCTIONS
7609 Sprinter Instructions 3-5-14.docx
Page 1 of 2
Sprinter Camera Installation Instructions, 2007 – current
(Kit # 9002-7609)
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in Kit:
CHMSL Mount Camera and Harness
Video Harness
Chassis Harness
Power Harness
Female to Male RCA Adaptor (not shown at right)
These Instructions
Tools & Supplies Needed:
Multi-meter or computer-safe test light
Plastic Trim Removal Tool
Electrical Tape or Heat Shrink Tubing
Soldering Iron (recommended)
Solder (recommended) or T-Taps
Wire Ties (recommended)
Safety Precautions:
•
Work in a well ventilated area that is clear of obstructions.
•
Secure vehicle with tire chucks in both front and rear of tires.
•
Turn vehicle accessories OFF and ensure ignition key is in OFF position.
•
Wear safety goggles and snug fitting clothes.
•
Use tools only for their intended purpose and which are in good repair.
•
Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions. The latest full color
instructions can be accessed at www.brandmotion.com
Step 1: Use a Phillips screwdriver to remove two
screws retaining the Center High-Mount Stop Lamp or
CHMSL
(commonly known as the Third Brake Light.) Save
screws to attach Camera.
Step 2: Disconnect the brake lamp socket from the
CHMSL and remove the CHMSL.
Step 3: Thread Camera Harness video and jumper
connector ends through CHMSL opening.
Step4: Attach Camera using existing screws.
CAUTION:
Do not over tighten.
Step 5:
Connect Camera Harness to supplied Chassis
Harness.
Step 6: Route Chassis Harness towards the video /
Navigation display.
Run Chassis Harness over the wheel
housing and underneath the door sill nearest ignition power.
Step 7: Connect Chassis Harness to supplied Video
Harness.
Step 8: Secure Chassis Harness to existing vehicle
wiring
. Avoid binding or otherwise damaging the harness.
(Recommended: Wire Ties or Electrical Tape.)
Step 9: Connect Video Harness to supplied Power
Harness.
