Blaze BLZ-3-CART, Assembly

Page: 1 / 3

BLAZE GRILL CART ASSEMBLY
Tools Needed : #2 Phillips Head Screw Driver – “Not Included”
Before getting started:
Unpack and lay out all of the included parts. Most of the stainless steel pieces come with a white
protective film. Remove all of the white plastic film and pay no attention to the print on the film as it
has nothing to do with the assembly instructions.
Take caution with the stainless steel components as to not scratch them during the assembly process.
Use a non-aggressive surface and protect the stainless steel as best as possible.
All of the screws in the hardware pack are the same. 16 M5x12 screw will be paired with a M5 lock
washer first, and then a M5 flat washer for installing the casters to the base. All other connections will
be made with a screw only.
Only the screws for the door handles are different and those are packaged with the handles them self.
The parts diagram has the parts labeled in the order in which they are used. Use the diagram as a
reference, while following the steps below.
1. Bottom Cart Panel - Flip the panel upside down on a protected surface exposing the four
locations where the casters attach. There are two runners on the bottom cart panel bottom with
4 nutserts (female threaded posts which a screw goes into) on each end of each runner. This is
the location where the casters install.
2. Attach the four casters - Use the locations described above and tighten completely. Once
complete, lock the locking casters and then turn the bottom panel right side up.
3. Attach the LP tank Support - This piece gets installed on the underneath side of the cart with
the two screws going into it from the top of the bottom cart panel. The large bolt on the LP tank
support threads into the LP tank’s lower ring to hold it firmly onto the cart bottom. Install the LP
tank support with two screws and tighten.
4. Attach the Tank Interference Bracket - (Not included for a 3 burner cart model). This pieces are
intended interfere with a second LP tank being stored inside the grill cart which is not permitted.
Using 4 screws, attach and tighten the Tank Interference bracket to the 4 nutserts adjacent to
the large circular cutout for the LP tank (see diagram)
(For the remainder of the grill cart assembly, the use of a second person is required and will
make for an easier time assembling).
5. Attach the right and left side cart panels - The right and left side panel can be identified as
follows. The top rail of each side cart panel is a solid surface with no openings for anything to
screw downward into it. The bottom sides have three openings per panel for screws which are
used to attach to the bottom cart panel. The Front side of each cart panel has a cluster of three
nutserts within 1.5” of each other which attach the front strut assembly. Attach both the left