![background image](http://html1.mh-extra.com/html/binks/102-2400/102-2400_instruction-manual_2752742001.webp)
Binks MODELS 102-2400 FRP,
102-2500 GEL-COAT, AND
102-2545 VINYL ESTER
AIR-ASSISTED AIRLESS
CENTURY SPRAY GUNS
Replaces
Part Sheet
77-2520R-7
Part
Sheet
77-2520R-8
Be sure you understand
ALL
of the following instructions
thoroughly
BEFORE
operating any part of the airless equip-
ment system.
CONSULT YOUR BINKS REPRESENTA-
TIVE TO CLEAR UP ANY ITEMS OF INSTRUCTION
YOU DO NOT UNDERSTAND.
1. Under no circumstances should the spray gun be carelessly
handled nor its spray (even when the nozzle is removed)
directed at close proximity at any part of the human body.
2.
NEVER
clean, change, or remove nozzle from the spray
gun without doing the following:
a. Lock trigger (62) by pushing forward. Rotate locking
block (68) in upward position.
b. Shut off pump and turn off air supply.
c. Release fluid pressure in the entire system, from pump
to spray gun. Stop pump in down position.
3.
NEVER
attempt to force the flow of liquid backward
through the gun.
4.
NEVER
plug a hose leak with your finger, with adhesive
tape, or other “stop-gap” device.
5.
NEVER
operate the airless system with a defective hose.
ALWAYS
replace the defective hose immediately. For
continuing safety, users are urged to:
a.
ALWAYS
handle carefully all hose connections, joints,
and seating surfaces on the spray gun to prevent dam-
age.
b.
NEVER
kink or bend the fluid hose into less than a
four inch radius.
c.
FREQUENTLY
check the hose for kinks or abrasions.
These may develop into a rupture.
d.
NEVER
use standard hardware to modify the airless
system.
ALWAYS
use Binks high pressure fittings
only.
6. The airless pump must be grounded before operating the
airless system.
WARNING — HIGH PRESSURE — WARNING
UP TO 2500 POUNDS PER SQUARE INCH
•
DO NOT POINT SPRAY GUN AT ANY PART OF THE HUMAN BODY
•
FLUID UNDER HIGH PRESSURE CAN PENETRATE THE SKIN AND CAUSE SEVERE INTERNAL INJURY
•
IN CASE OF INJURY OBTAIN MEDICAL ATTENTION IMMEDIATELY
•
BE SURE TO REPORT NATURE OF INJURY AND TYPE OF FLUID OR SOLVENT TO THE DOCTOR
AIR ASSIST
AIR CAP
CATALYST
INJECTOR
CATALYST FILTER
CENTURY TIP
TRIGGER LOCK
AIR ASSIST INLET
1/4 NPS(m) / 1/4 NPT(m)
CATALYST INLET
1/4 NPS(m)
RESIN INLET
1/4 NPS(m)
102-2400 Century Wet-Out Gun
111-4052
Wrench
102-2521
Catalyst Injector
102-2526
Catalyst Injector
102-2531
Catalyst Injector
106-1170
Kit
102-2500 Century Gel-Coat Gun
111-4052
Wrench
102-2515
Catalyst Injector
102-2518
Catalyst Injector
102-2521
Catalyst Injector
106-1170
Kit
102-2545 Century Vinyl Ester Gun
111-4052
Wrench
102-2521
Catalyst Injector
102-2526
Catalyst Injector
106-1170
Kit
CHOPPER INLET
(not shown—see page 4)