02635
Elevated Feed
477 MHz
3 & 6dB Kit
Manufactured in Australia
by Benelec Pty. Ltd.
Heavy duty, stainless steel &
fibreglass construction
Pre-terminated cables, NO tools
required
UV stabilised PVC heat shrink for
long lasting reliability
Complete kit includes stainless
spring & elevated feed base, 6dB &
3dB antennas, RG58 lead & plug
Pre-tuned antennas (no tuning
required)
Made using high quality
components
Designed and manufactured in
Australia by a 100% Australian
owned company
5 year guarantee
Specifications
Frequency:
476.42-477.40 MHz
Gain:
3dB, 6dB
VSWR:
<1.5:1 for band above
Ant.Length:
450 / 900 mm
Impedance:
50 Ohm
Polarization:
Vertical
Radiation:
Omni directional
Antenna Materials:
Solid Fibreglass Rod,
Brass, PVC Heat
shrink, CU & S/S
Radiator, PVC Cap
Base Material:
Stainless Steel Brass
Cable:
RG 58 C/U Mil-Spec
Benelec 05602 ABK
Termination:
PL259, UHF Plug
Manufactured:
By Benelec in Sydney,
Australia
5 Years Limited Warranty
IMPORTANT Satisfactory evidence of the original
purchase is required for warranty service
Terms of Warranty
Benelec Pty Ltd warrants that the product will be
free from defects in materials and craftsmanship for
the duration of the warranty period, subject to the
limitations and exclusions set out below.
Note that
product specifications are mainly derived from those
provided by manufacturers and although all care is
taken to ensure that these are described accurately
in all Benelec publications, no direct or consequential
responsibility can be attributed to Benelec as a result
of any inaccuracy in those specifications.
If a warranty claim is made, this warranty will not
apply if the Product is found by Benelec to be:
(A)
Damaged or not maintained in a
reasonable manner or as recommended
in the relevant Owner’s Manual;
(B)
Modified, altered or used in any manner
not authorised by Benelec;
(C)
Improperly
installed
contrary
to
instructions contained in the relevant
Owner’s Manual; or
(D)
Repaired by someone other than an
authorized Benelec Repair Agent in
relation to a defect or malfunction
covered by this warranty.
Statement of Remedy
If the Product is found not to conform to this warranty
as stated above, the Warrantor, at its discretion,
will either repair the defect or replace the Product
without any charge for parts or service. This warranty
does not include any reimbursement or payment of
any consequential damages claimed to arise from a
Product’s failure to comply with the warranty.
Our goods come with guarantees that cannot be
excluded under the Australian Consumer Law. You
are entitled to a replacement or refund for a major
failure and for compensation for any other reasonably
foreseeable loss or damage. You are also entitled to
have the goods repaired or replaced if the goods fail
to be of acceptable quality and the failure does not
amount to a major failure.
Procedure for Obtaining Warranty Service
Returned goods will not be accepted for repair or
replacement unless prior consent has been given
by Benelec. Returned goods must be accompanied
by suitable documentation clearly describing the
customer’s name, address, telephone number and
responsible person to contact as well as satisfactory
evidence of your original purchase (such as a legible
copy of the sales docket). Returned goods must
be suitably packed to ensure no damage in transit.
Damaged goods will not be accepted for return.
Freight on returned goods must be prepaid.
BENELEC PTY LTD
WWW.BENELEC.COM.Au
