Fig. 2
Fig. 1
TLED-I
INSTALLATION INSTRUCTIONS
SAVE THESE INSTRUCTIONS!
READ CAREFULLY AND FOLLOW ALL INSTRUCTIONS FOR YOUR OWN SAFETY
•
DISCONNECT AC POWER SUPPLY BEFORE SERVICING.
•
Installation and servicing of this equipment should be performed by qualified service personnel only.
•
Ensure the electricity connections conform to the National Electrical Code and local regulations if applicable.
•
Do not mount near gas or electrical heaters.
•
Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by
unauthorized personnel.
•
The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition. Any
modification or use of non-original components will void the warranty and product liability.
•
Do not use this equipment for other than intended use.
1
20070001 Rev 2 11/13
INSTALLATION INSTRUCTIONS
(DIRECT WALL MOUNTING TO RECESSED BOX)
1. The LEDs (light engine) is pre-installed. DO NOT OPEN UNIT.
2. Remove the mounting plate by loosening (2) allen set screws from the bottom of the canopy. (Fig. 1)
3. Fasten the mounting plate to the junction box, leveling the mounting plate by the level bubble to the horizontal
line. Use hardware provided with junction box. (Fig. 2)
•
www.barronltg.com
800.533.3948
allen screws
junction box
mounting plate
level
bubble
