EIRP305-T-1012qsg
Quick Start Guide
Elinx PoE Ethernet Switch
EIRP305-T
Items Included
1
2
Hardware Installation
3
LED Chart
4
Ports
5
Installation Complete
o
Ethernet
Switch
o
CD with Support Manual
o
This Quick Start Guide
o
Panel Mount Bracket
1.
Select a mounting location and install the
switch onto a piece of DIN rail or use the
included panel mount brackets for wall or
panel mounting
2.
Connect power to the switch
48
VDC
If redundancy is desired be sure to
connect two separate power supplies by
using the two DC inputs on the terminal
blocks
If only one power input is used the Fault
LED will light (this is normal)
LED
Description
Green
Power input 1 is active
P1
Off
Power input 1 is inactive
Green
Power input 2 is active
P2
Off
Power input 2 is inactive
Red
Power input 1 or 2 is inactive
Fault
Off
Power input 1 and 2 are both
active, or no power is present
Green
The port is supplying power to
the connected device
FWD
(1 to 4)
Off
No device attached or no power
being supplied
Green
Connected to network
Flashing
Networking is active
RJ-45
Upper LED
Off
Not connected to network
Yellow Full-duplex
link
Flashing Collision
occurs
RJ-45
Lower LED
Off
Half-duplex link or link down
RJ-45 ports
: The RJ-45 ports auto-sense for 10 or 100 Mbps
device connections. The auto MDI/MDIX feature allows
connections to switches, workstation and other equipment
without changing straight through or crossover cabling. The
charts below show the cable pin assignments for straight
through and crossover cables.
PoE ports
: The PoE ports on this switch follow Alternative A
standards and are limited to 15.4 Watts of power output per
port. Ports 1 thru 4 support the IEEE802.3af standard and
are classified as (PSE) power sourcing equipment, which
means they can be used to power (PD) powered devices.
MDI Cable Pinout
Pin
Signal
1 Tx+
2 Tx-
3 Rx+
6 Rx-
MDI-X Cable Pinout
Pin
Signal
1 Rx+
2 Rx-
3 Tx+
6 Tx-
1. Auto MDI/MDI-x is
supported. A straight
through or cross-over
cable may be used.
2. 10/100 auto
negotiation and full/half-
duplex are supported.
1. When the network cables are attached and power
is applied, installation is complete.
2. The switch will automatically discover network
devices, populate its MAC address table, and
pass traffic to the appropriate ports.
