OUTDOOR LIGHTING – LINEAR FLUORESCENT WALKOVER LUMINAIRE
INSTRUCTION LEAFLET
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
LEAVE A COPY FOR THE USER / MAINTENANCE ENGINEER FOR FUTURE REFERENCE
USING THIS INSTRUCTION LEAFLET
This instruction leaflet has been designed as a general installation guide to help you install your particular outdoor
luminaire. Please pay particular attention to how your luminaire is wired. If you require any guidance or any further
information regarding your outdoor luminaire, please contact us via the details below or visit our web site.
IMPORTANT INSTALLATION INFORMATION
•
Installation should be carried out in accordance with the latest edition of the I.E.E. Wiring Regulations (BS7671)
and taking into consideration the latest Building Regulations. If in doubt, consult a qualified electrician.
•
Before commencing any installation or maintenance work, ensure electricity is switched off at the mains.
•
Please take note of the maximum rated voltage for your luminaire.
•
Please take note of the IP (Ingress Protection) rating of your luminaire when deciding location.
•
Always allow sufficient slack in the supply cable in order to remove the luminaire from its position for any future
maintenance.
•
Please take note of the maximum lamp wattage for your luminaire as detailed on the product label.
•
Ensure that ALL electrical connections are tight with no loose strands, including factory made connections.
•
Care must be taken for installations where the lens or bezel may come into contact with bare skin.
•
All luminaries run HOT. It is the installer’s responsibility to consider fire & safety risk and take appropriate
precautions.
•
Please take note of the nearest illuminated surface as detailed on the product label.
LABEL SYMBOLS EXAMPLES
•
Luminaire can be mounted on a normally flammable surface e.g. a material based on wood.
•
Luminaire can not be mounted on normally flammable surfaces.
•
Double insulated – does not require an earth connection.
•
Luminaire must be earthed.
•
Complies with Class 3 – SELV (Safety Extra Low Voltage) less than 50VAC.
•
Nearest illuminated surface in front of the luminaire.
•
Indicates a non-replaceable LED (Light Emitting Diode) lamp.
•
IP44 - Protected against splashing water.
•
IP65 – Protected against low pressure jets of water.
•
IP68 – Protected against submersion in water.
IMPORTANT USER INFORMATION
•
Always switch off mains supply before installation, servicing, fitting or changing the lamp.
•
Replace failed lamps immediately. Allow the lamp and fitting to cool before replacing lamp. Check that the correct
lamp type and wattage is fitted. Dispose of failed lamps correctly.
•
Replace any cracked protective glass immediately and use only original parts to do this.
•
It is recommended to clean every two to three months to preserve the finish of this product. Do not use solvents
or aggressive cleaning agents.
