background image

Document Version: AU-A1ZBSCCX_V3_18

www.auroralighting.com

MODEL

AU-A1ZBSCCX

INPUT VOLTAGE (V)

12-24V DC

INPUT CURRENT

8A @ 24V DC / 12V DC

OUTPUT VOLTAGE

12-24V DC

NUMBER OF OUTPUTS

1 (includes warm white and cool white)

MAX LOAD

96W @ 24V DC per output 
48W @ 12V DC per output

AMBIENT TEMPERATURE LIMITS

-20°C~+50°C

IP RATING

IP20 (Indoor Use Only)

NUMBER OF OPERATING CYCLES

1E4

CIRCUIT DISCONNECTION

Electronic disconnection

PROTOCOL

ZigBee 3.0

CONDUCTOR TYPE & SIZE

Twin and Earth 0.75~1.5 mm

2

 (UK)

Flat x2C+E 0.75~2.5 mm

2

 (Australia)

FREQUENCY BAND

2.405 - 2.483GHz

MAX OUTPUT RF POWER

12.66dBm

INSULATING MATERIALS

Polycarbonate

GLOW-WIRE TEMPERATURE

850

°C

PROTECTIVE DEVICE

100°C Recoverable temp control

•  There are no restrictions of use.
•  Installation must be carried out in accordance with the latest edition of the 

Wiring Rules by a qualified electrician.

•  Earth terminal is for Termination only.
•  Hereby, Aurora Limited declares that the radio equipment type  

AU-A1ZBSCCX is in compliance with Directive 2014/53/EU. The full text 
of the EU declaration of conformity is available at the following internet 
address: 

www.auroralighting.com/ProductDetail/AU-A1ZBSCCX

2

4

8

Download / control through the 

AOne App

7

USING THE APP TO CONNECT THE LED STRIP 

CONTROLLER TO THE HUB

1.  Download the AOne App from the App Store.
2.   Follow instructions on the App to send the hub into pairing mode and pair 

your devices (further details below).

3.  Put the controller into pairing mode by:
a)  Connecting the controller to a power outlet and turning on the power, or,
b)  Pressing the pairing button for 3 seconds, or,
c)   Powering the controller off for a minimum of 2 seconds and back on 

again 6 times. The on periods must be between 0.5 - 1.5 seconds.

The LED Strip will flash twice to indicate it has entered pairing mode.
The LED Strip will flash a third time to indicate that it has successfully 
paired with the hub.
The controller can then be controlled using the AOne App.

LED Strip

220-240V

Mains Supply

5

IMPORTANT INFORMATION:

 

•  The strip controller works on 12V/24V DC, it cannot be 

used with 220-240V AC directly.

•  Remove any existing dimmers from the circuit. 

•  The strip controller fits between the non-dimmable LED 

driver and LED strip (LED driver NOT included). 

•  We recommend LED strip below 10W per metre can run a 

maximum of 10m and for LED strip above 10W per metre 

a maximum of 5m. This is based on an incoming cable 

between driver and start of LED strip of 5m.  

•  For further details please check specific LED strip data.

1

CW-

+

+

+

V+

V-

WW-

LED D

river

CABLE T

O

LED STRIP

  

+ - -

12-24V DC

12-24V DC

CABL

E

CABLE FROM LED DRIVER

3

6

Pairing

button

Reviews: