1/4
AtlasSound.com
TELEPHONE: (800) 876-3333
FAX (800) 765-3435
©2011
Atlas
Sound
L.P
.
All
rights
reserved.
Atlas
Sound
is
a
trademark
of
Atlas
Sound
L.P
.
All
other
trademarks
are
the
property
of
their
respective
owners.
All
specs
are
subject
to
change
without
notice.
A
TS003980
RevA
1/11
ZCM-V2
Zone Controller Pro Install Sheet
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
Introduction
The ZCM-V2 Zone Controller Pro is an analog gateway for Atlas Sound
IP paging systems. This model is compatible with Atlas Sound's
ControlKom
©
and Singlewire’s InformaCast
©
software. The ZCM-V2
provides a line level output to connect to Atlas Sound commercial
amplifiers and an 8
Ω
, 25V, 70.7V amplified output to drive small analog
speaker zones. It also includes 2 GPI Inputs, 2 GPI Outputs and
Microphone input for talk back applications. Power can be supplied via
plug-in transformer (IPS-PSU) or by 802.3af compliant PoE network
switches. All control features of the ZCM-V2 are software controlled.
Functionality
Once connected to a network and powered, the ZCM-V2 will boot up
and obtain an IP address from a DHCP server on the network. Next,
the unit will listen for an SLP broadcast from InformaCast / ControlKom
software telling the unit where the service is running on the network.
Once the ZCM-V2 identifies the software’s location, it will request
the InformaCastSpeaker.cfg file and register. The MAC address of the
ZCM-V2 will then show in the ‘Unidentified Speakers” page in the
software. Please refer to the installation manual of the software for
additional configuration settings.
After the module has registered with the software, its HTTP page can
be accessed by navigating to its IP address with any browser. This page
will show its current firmware version and registration information.
Use Only if 802.3 af
Compliant POE Switch
Not Available
Input / Output
1601 Jack McKay Blvd.
Ennis, TX 75119
800.876.3333
AtlasSound.com
Contact Closure In / Out
Positive Tip Polarity
12VDC 1 AMP min
ZCM-V2 Zone Controller
GP
I–
I 1
GP
I–
I 2
GPI
–O 1
GPI
–O 2
3.3VDC
GND
MIC IN
GND
8
Ω
70.7V
25V
8
Ω /
25V /
70.7V COM
LINE
+
LINE / COM
Remove
For 8
Ω
1 2 3456 7
8
9 10
Microphone Input
1.
8
2.
Ω
Jumper (Remove this Jumper for 8
Ω
Operation)
8
3.
Ω
Speaker Output
70.7V Speaker Output
4.
25V Speaker Output
5.
8
6.
Ω
, 25V, and 70.7V Speaker Output COM
Line Level Output
7.
GPI Inputs
8.
GPI Outputs
9.
DC Output and COM for Use with GPI I/O
10.
