AT100 Quick Installation Guide
1. Install the GSM SIM card
Insert the SIM card into the small slot in the side of the AT100, until it is flush with the edge of
the case. Correct orientation of the SIM card is important for correct operation and to avoid
damage to the SIM – see below:
2. Protect SIM card
Once the SIM is installed, it is advisable to cover the SIM slot with tape or an anti-tamper
label, to protect against ingress of dirt and deter tampering.
3. Power
Supply
The AT100 should be connected to a permanent power source - voltage range 6 to 30 VDC,
with a 1.0A in-line fuse, fitted to both POSITIVE and GND feeds. If using CB001 Power
Cable, hook up the RED and BLACK wires appropriately.
4. Ignition Sense Input
The white IGN SENSE wire included in the standard CB001 power loom is used to sense the
vehicle’s ignition state. This wire must be connected to a source which goes high (12/24V)
only when the vehicle ignition is on. In line resistors are NOT REQUIRED.
5. Additional
inputs/PTOs
If additional inputs (PTOs) are required, fit a CB004 or CB005 cable to the 36 way data
connector and connect the appropriate inputs as necessary. No ground return is necessary,
as the ground is common with the power source. In line resistors are NOT REQUIRED. No
wires should be shorted together and unused wires should be insulated.
Signal
CB004 Cable
CB005 Cable
Digjtal 1 – IGNITION
WHITE
YELLOW
Digital 2 – PANIC BUTTON
ORANGE
ORANGE
Digital 3
CYAN
GREEN
Digital 4
PURPLE
BLACK
Digital 5
RED
RED
Digital 6
BROWN
BROWN
ADC INPUT
PINK
N/A
