Application:
Provides safe latching or secure deadlocking for sliding
aluminium and timber doors.
Operation:
Snib to latch, key to deadlock.
077278 - June14
• Several chassis fixing screws are
provided to suit different door
thicknesses
• Screws are a “taptite” screw that makes
its own thread – therefore the outer
pulls are not pre threaded
• Use the table to identify
which are the correct
length fixing screws for
your application
4. Screw Selection
Door Thickness
Screw Selection
19-29mm
M4 x 50mm
30-39mm
M4 x 60mm
40-49mm
M4 x 70mm
Template
75
75
62.5
62.5
LINE 1
BACK WALL OF JAMB
FIXED DOOR FRAME FRONT EDGE
LINE 2
11
16
33
41
41
ø
3
ø
10
Tools Required:
• Drill
• Phillips Screwdriver •
ø
10mm Drill Bit
•
ø
3mm Drill Bit • Hacksaw or cutters • Rule and pencil or marker
Installation Instructions
• Place the cylinder with tail in the outer
pull and place cylinder retainer over
the back of the cylinder as shown
3. Cylinder Preparation
Surface Fix (Follow holes labelled A)
• Ensure door is closed correctly. Place
template on the inside surface of the jamb
(fixed door frame) at the desired height
• If ‘X’ is greater than 19mm, align ‘LINE 1’
with the outer edge
• If ‘X’ is less than 19mm align ‘LINE 2’
against the back wall
• Mark and drill all holes marked ‘A’
(3x
ø
10mm, 2x
ø
3mm)
• For 3x
ø
10mm holes - do not fold
template over outer edge step
1. Door Preparation
Note:
If the Flat Outer Pull option is being fitted, drill centre hole ø4mm and refer to step 9.
• Remove components from packaging.
If beaks are in the locked position shown,
push the snib button down to retract
the beaks
• Press in the DCD (door closed detect)
button and remove the lock chassis from
inside the D-Handle body
2. Lock Chassis and Handle Preparation
Press in
DCD Button
Locked
Position
Snib Button
Outer Edge
Back Wall
D-Handle
Cylinder
Wedge
Cylinder
28mm Screws
Chassis
Fixing Screws
Lock Chassis
Cylinder Retainer
Cylinder with Tail
Outer Pull
Strike Body
Strike Cover
7mm Screws
16mm Fixing
Screws
Pack Contents
• Place the outer pull on the external face of
the door with the tail passing through the
centre hole
• Mark and cut the cylinder tail piece 10-
12mm past the door (allow an extra 5mm
if a handle packer is to be fitted)
Side Fix (Follow holes labelled B)
• Fold template 90° along ‘LINE 1’
• Ensure door is closed correctly. Place
template against the door surface at
the desired height
• Mark and drill all holes marked ‘B’
(3x
ø
10mm, 2x
ø
3mm)
10-12mm
Sliding Door Lock
A
A
A
B
B
B
X
