XPander Smoke and Heat Detectors
Installation Guide
General
Do not install any XPander equipment until a full site survey has been completed using the
XPander site survey tool. A maximum of 5 interfaces are permitted for each site. For sites
that require more than 5 interfaces please contact Apollo. All installation engineers must
have had certified XPander training.
The XPander smoke and heat detector variants are available under the following part
numbers:
Complete Units
Part Number
Description
XPA-CB-12034-APO
XPander Optical detector with base
XPA-CB-13032-APO
XPander Multisensor detector with base
XPA-CB-11170-APO
XPander Heat A1R detector with base
XPA-CB-11171-APO
XPander Heat CS detector with base
Spares
Part Number
Description
XPA-WB-10022-APO
XPander Mounting base only
XPA-OP-12034-APO
XPander Optical head only
XPA-OH-13023-APO
XPander Multisensor head only
XPA-HT-11170-APO
XPander Heat A1R head only
XPA-HT-11171-APO
XPander Heat CS head only
The installation must conform to BS5839-1 (or applicable local codes).
All detectors are suit-
able for indoor use only.
© Apollo Fire Detectors Limited 2006-2010
Apollo Fire Detectors Limited, 36 Brookside Road, Havant, Hampshire, PO9 1JR, UK
Tel: +44 (0) 23 9249 2412 Fax: +44 (0) 23 9249 2754
Email: [email protected] Website: www.apollo-fire.co.uk
1
39214-394/Issue 3
Battery Type
6 x AA, 1.5V Alkaline Duracell Procell (MN1500, LR6)
When replacing batteries, allow the device to power down for a period of two minutes
before installing replacements.
Note: When replacement batteries are required all batteries must be replaced together.
Technical Data
Operating voltage
2.8-5VDC
Operating temperature
–10°C to +50°C
