FULL SIZE UTILITY VEHICLE
ASSEMBLY INSTRUCTIONS
!
TOOLS REQUIRED
WARNING
WARNING
!
1 Uncrating the vehicle (refer to figure 1)
2: Remove Top
1: Remove Ends
3: Remove Sides
RISK OF SERIOUS INJURY OR DEATH
2018 MODEL
Congratulations on the purchase of your Utility Vehicle! These
instructions will guide you through the assembly process. Carefully
read these instructions and familiarize yourself with the tools and
fasteners required before starting the assembly of your vehicle.
The following fasteners are included for the assembly of this vehicle.
please make sure you have all fasteners before beginning assembly. If
any parts are missing or if you have questions regarding the packaged
vehicle, call American Landmaster customer service at 800-643-7332.
Wear proper eye protection during the uncrating and assembly
process to avoid potential eye injuries.
The Brush Bars and the Shoulder Belts are critical parts of the
Operator / Passenger safety system on this vehicle. Do not attempt to
operate the unit until these components have been properly installed.
16616 rev. B page 1 of 4
• Wear your Safety Glasses to prevent eye injury.
• Using the Hammer and Pry Bar, remove crate ends and discard.
• Carefully pry and remove crate top and discard.
• Remove crate sides and discard.
• Using a Box Cutter, cut and remove the hold down ties.
• Unpack all loose components and set aside.
Hammer
Box or Side Cutter
Pry Bar
Safety Glasses
½” Wrench
½” Socket
¼” Allen Wrench
Phillips Screw Driver
7/16” Wrench
3/16” Allen Wrench
(2) 15/16” Wrench
(2) 17mm Wrench
overhead bars
front bumper
front tires
seat back
seat bottom
underseat storage tray
(not available on all units)
(8) - 5/16-18 x 2 Socket yellow (2-50172)
(8) - 5/16 Bent washer zinc (2-50702)
(8) - 5/16-18 Nylon LN yellow (2-50007)
Overhead bars / Bed tubes (black bag)
Bag contents
(4) - 5/16-18 x 1.25 Hex head bolt (2-50161)
(4) - 5/16-18 Keps lock nut yellow (2-50005)
(4) - 5/16 SAE flat washer yellow (2-50701)
Bumper (red bag)
(4) - 1/4-20 x 1 HHCS Gr.5 zinc (2-50087)
(4) - 1/4-20 Nylon LN yellow (2-50001)
(4) - 1/4 SAE flat washer yellow (2-50717)
(4) - 1/4-20 x 3/4 Carriage bolt Gr.5 zinc (2-50087)
Fenders (white bag)
(6) - 1/4-20 x 3/4 Socket SS (2-50636)
(6) - 1/4-20 Nylon LN yellow (2-50001)
Steering wheel (clear bag)
(2) - 5/8-11 x 4 HHCS Gr.8 yellow (2-50255)
(2) - 5/8-11 Nylon LN yellow (2-50015)
Cargo Bed (clear bag)
(2) - M12 x 1.75 x 25 FHCS (15829)
(2) - M12 x 1.75 x FH toplock hex nut (2-50001)
Seat Belt (yellow bag)
Figure 1
Typical crate construction
