MM-060
REV00-0825015
1 of 3
Installation Guide
Universal Wall Mount
Before beginning the installation process, fi rst determine if the mount
will attach to the rear or the bottom panel of the speaker then select the
corresponding instructions below:
Rear Mounted Confi guration
Assemble the Pivot U-Bracket to the set of holes closest to the bracket pivot
using the supplied ¼-20 x5” long screws.
Bottom Mounted Confi guration
Assemble the Pivot U-Bracket to the set of holes farthest from the bracket
pivot using the supplied ¼-20 x5” long screws.
Step 1: Assemble Tilt Mechanism
Assemble the free end of the threaded pivot bar to the Pivot-U-bracket using
the supplied fl at head screws and tighten (Figure 3).
Step 2a: Install Wall Plate to Wall
Orient the wall plate with the smaller through hole under the larger hole and
place over the desired wall location. Using a level, mark the mounting holes,
then pre-drill the holes using an undersized drill bit.
Secure the Wall Plate to the wall using the appropriate mounting hardware.
DO NOT INVERT THE WALL PLATE. THE TAB MUST ALWAYS BE ON
THE TOP SIDE.
Caution - If in doubt, consult a hardware specialist in the proper selection
for mounting to the structure (Figure 4). If wiring is coming out from the wall,
make sure that it is long enough to go out from the square hole of the wall
mount plate.
The versatile MultiMount™ MM-060 wall mounts loudspeakers weighing up to
60 lbs to walls using the standard four-hole mounting patterns located on both
the back and the bottom panels.
The MM-060 simplifi es and speeds up installation while off ering a very
versatile range of mounting and aiming options.
Note to installers
Due to the wide variety of wall structures, materials and mounting
methods, these instructions assume that the installing contractor will
exercise proper judgment in selecting the mounting area and hardware.
As a guide, the installation, when complete should be capable of
supporting 5 to 10 times the actual applied load. Also, always use a back
up safety system such as a safety cable.
To assure a trouble free installation, read through and follow these
instructions carefully before beginning. If you have doubts about
the integrity of the structure you are mounting to or you are not
sure about the proper hardware to use, consult a structural and/or
hardware specialist.
Be sure that all of the following items are included in this kit before proceeding:
1 pc Wall mounting plate
1 pc Speaker adapter assembly
1 pc Hardware kit
1 pc Instruction sheet
Note: Screws and washers to attach speaker to adapter plate are not included
Rear Mounted Confi guration
Bottom Mounted Confi guration
