ZyXEL Communications ZyWall, Reference Manual, Page: 20 / 394

Chapter 1 Command Line Interface
ZyWALL (ZLD) CLI Reference Guide
20
1.6.3 Entering Partial Commands
The CLI does not accept partial or incomplete commands. You may enter a unique part of a
command and press
[TAB]
to have the ZyWALL automatically display the full command.
For example, if you enter
config
and press
[TAB]
, the full command of
configure
automatically displays.
If you enter a partial command that is not unique and press
[TAB]
, the ZyWALL displays a list
of commands that start with the partial command.
Figure 13 Non-Unique Partial Command Example
1.6.4 Entering a ? in a Command
Typing a
?
(question mark) usually displays help information. However, some commands
allow you to input a
?
, for example as part of a string. Press [CTRL+V] on your keyboard to
enter a
?
without the ZyWALL treating it as a help query.
1.6.5 Command History
The ZyWALL keeps a list of commands you have entered for the current CLI session. You can
use any commands in the history again by pressing the up (
y
) or down (
z
) arrow key to scroll
through the previously used commands and press
[ENTER]
.
1.6.6 Navigation
Press
[CTRL]+A
to move the cursor to the beginning of the line. Press
[CTRL]+E
to move the
cursor to the end of the line.
1.6.7 Erase Current Command
Press
[CTRL]+U
to erase whatever you have currently typed at the prompt (before pressing
[ENTER]
).
1.6.8 The no Commands
When entering the no commands discribed in this document, you may not need to type the
whole command. For example, with the “
[no] mss <536..1452>
” command, you use
“
mss 536
” to specify the MSS value. But to disable the MSS setting, you only need to type
“
no mss
” instead of “no mss 536”.
Router# c
[TAB]
clear configure copy
Router# co [TAB]
configure copy