ZyXEL Communications STB-1003, User Manual

Page: 29 / 98

Chapter 2 The Menu System
STB-1003 User’s Guide
29
2.3.3 The Advanced Setup: Network Menu
Use this menu to set up the STB’s IP address, media server information, and homepage.
This menu differs according to the
Mode you select.
• Select DHCP to have the STB obtain a dynamic IP address automatically from a DHCP
server. See Section 2.3.3.1 on page 29 . DHCP is the default setting.
• Select Static to assign an IP address to the STB. See Section 2.3.3.2 on page 30 .
• Select PPPoE to use a Point-to-Point Protocol over Ethernet service. See Section 2.3.3.3
on page 31 .
2.3.3.1 Network: DHCP
Select DHCP in the Network menu. The following menu displays.
Figure 10 The Network: DHCP Menu
Flash This shows the quantity of available flash (non-volatile) memory.
Memory This shows the quantity of available run-time memory.
MAC Address This shows the hardware Media Access Control address of the
STB.
IP Address This shows the IP address currently assigned to the STB. You can
change this in the Advanced Setup: Network menu.
STB Version This shows the firmware version running on the STB. Check this
before you upload new firmware.
Bootloader This shows the version number of the software that loads the
STB’s operating system on startup.
Kernel This shows the version number of the code that controls the STB’s
basic operations.
Rootfs This shows the version number of the STB’s filesystem code.
Apps This shows the version number of the STB’s software applications.
Table 6 The Information Menu
LABEL DESCRIPTION