ZyXEL Communications STB-1001S, User Manual

Page: 35 / 137

Chapter 2 The Menu System
STB-1001S User’s Guide
35
The following table describes the labels in this menu that were not already described in table 6 .
2.3.4 The Advanced Setup: Firmware Upgrade Menu
Use this menu to get new firmware from the autoconfiguration server. You must be connected
to the network and have a valid autoconfiguration server address configured in the
Advanced
Setup: Network menu’s ACS Server field (see Section 2.3.3 on page 32 ).
Select Firmware Upgrade from the column on the left of the screen. The following menu
displays.
Figure 13 The Firmware Upgrade Menu
If you want to get new firmware from the auto-configuration server, click Upgrade Now . The
STB contacts the autoconfiguration server and downloads the firmware.
If the following screen displays, the STB cannot reach the autoconfiguration server. Check the
settings in the
Advanced Setup: Network menu (see Section 2.3.3 on page 32 ) and try again.
Figure 14 Firmware Upgrade Error
Table 8 The Network: PPPoE Menu
LABEL DESCRIPTION
Mode Select PPPoE to use a Point-to-Point Protocol over Ethernet
service.
User Name Enter the username for your PPPoE account.
Password Enter the password for your PPPoE account.