ZyXEL Communications STB-1001S, User Manual

Page: 33 / 137

Chapter 2 The Menu System
STB-1001S User’s Guide
33
• Select DHCP to have the STB obtain a dynamic IP address automatically from a DHCP
server. See Section 2.3.3.1 on page 33 . DHCP is the default setting.
• Select Static to assign an IP address to the STB. See Section 2.3.3.2 on page 33 .
• Select PPPoE to use a Point-to-Point Protocol over Ethernet service. See Section 2.3.3.3
on page 34 .
2.3.3.1 Network: DHCP
Select DHCP in the Network menu. The following menu displays.
Figure 10 The Network: DHCP Menu
The following table describes the labels in this menu.
2.3.3.2 Network: Static IP Address
Select Static in the Network menu. The following menu displays.
Table 6 The Network: DHCP Menu
LABEL DESCRIPTION
Mode Select DHCP to have the STB obtain an IP address automatically.
TFTP Server Enter the IP address of the Trivial File Transfer Protocol Server
which supplies TV and video to the STB.
Home URL Enter the address of the homepage the STB uses as the Home
menu (the screen that displays when you press the HOME key on
the remote control).
ACS Server This field is for remote management. Change the information in
this field only if you were specifically told to do so.
Enter the address of the auto-configuration server from which the
STB gets its operating settings.
NTP Server Enter the address of the Network Time Protocol server from which
the STB gets its date and time settings.
Save Select this to store your configuration changes.