Prestige 794M User’s Guide
Chapter 3 LAN
40
Figure 20
LAN: Ethernet
The following table describes the labels in this screen.
3.4 Ethernet Client Filter
Use the
Ethernet Client Filter
screen to set the Prestige to allow or block specified Ethernet
devices from accessing the LAN.
Click
LAN
and
Ethernet Client Filter
in the navigation panel to display the configuration
screen.
Table 13
LAN: Ethernet
LABEL
DESCRIPTION
Primary IP Address
IP Address
Type the IP address of your Prestige in dotted decimal notation. 192.168.1.1 is the
factory default.
IP Subnet Mask
The subnet mask specifies the network number portion of an IP address. Your
Prestige automatically calculate the subnet mask based on the IP address that you
assign. Unless you are implementing subnetting, use the subnet mask computed
by the Prestige.
RIP
The
RIP
field controls the format and the broadcasting method of the RIP packets
that the Prestige sends (it recognizes both formats when receiving).
Select
RIP v1
if you are unsure what RIP version other Ethernet device(s)
supports. RIP v1 is universally supported.
Select
RIP v2
to send detailed routing data.
Select
RIP v2 Multicast
to set the Prestige to send routing data in RIP-2 format
using multicasting.
Secondary IP Address
You can assign a different IP address (in the same subnet as the primary IP address) to the LAN
interface.
IP Address
Type the secondary IP address of your Prestige in dotted decimal notation.
Note:
Make sure this IP address is in the same subnet as the
primary IP address above.
Apply
Click
Apply
to save your changes back to the Prestige.
