![background image](http://html1.mh-extra.com/html/zyxel-communications/msap2000-aams/msap2000-aams_user-manual_944762078.webp)
78
MSAP2000 AAMS User’s Guide
Table 21
IGMP Filter Profile (continued)
LABEL DESCRIPTION
Index
This is the number of the IGMP filter profile. Click a profile’s index number to
edit the profile. You cannot edit the
DEFVAL
profile.
Name
This name identifies the IGMP filter profile.
Delete Select
the
Delete
check box and click
Delete
to remove an IGMP filter profile.
You cannot delete the
DEFVAL
profile.
Name
Type a name to identify the IGMP filter profile (you cannot change the name of the
DEFVAL profile). You can use up to 31 ASCII characters; spaces are not allowed.
Start IP
Enter the starting multicast IP address for a range of multicast IP addresses to
which you want this IGMP filter profile to allow access.
End IP
Enter the ending multicast IP address for a range of IP addresses to which you
want this IGMP filter profile to allow access.If you want to add a single multicast
IP address, enter it in both the
Start IP
and
End IP
fields.
Add Click
Add
to save your changes to the MSAP2000 AAMS’s volatile memory.
The MSAP2000 AAMS loses these changes if it is turned off or loses power, so
use the
Config Save
link on the navigation panel to save your changes to the
non-volatile memory when you are done configuring.
Cancel Click
Cancel
to start configuring the screen again.
7.16 Line Rate Information
Click
Basic Setting
and then
Line Data
in the navigation panel to open the
following screen. This screen displays an ADSL port's line operating values.
Information obtained prior to training to steady state transition will not be valid or
will be old information.
Figure 36
Line Rate Information