Chapter 14 Access Control
AMG1001-T/AMG1011-T Series User’s Guide
85
longer than this timeout period. The management session does not time out when a statistics
screen is polling.
14.1.4 Configuring the Access Control Setup Screen
Click
Access Management
>
ACL
to open the following screen.
Figure 46
Access Management > ACL
The following table describes the fields in this screen.
Table 33
Access Management > ACL
LABEL
DESCRIPTION
Access Control Setup
ACL
Select
Activated
to enable access control on the AMG1001-T/AMG1011-T or select
Deactivated
to disable it.
Access Control Editing
ACL Rule Index
Select an index rule number in order to edit or delete it.
Active
Select
Yes
to enable this active control rule or
No
to disable it.
Secure IP
Address
Enter the range of IP addresses of computers that are allowed to access the device.
0.0.0.0 ~ 0.0.0.0 means that any computer can access the AMG1001-T/AMG1011-T. If
you want just one computer to be able to access the AMG1001-T/AMG1011-T, then enter
its IP address in both fields.
Application
Select the service through which the computer can access the device.
•
If you want to allow a user to connect to the AMG1001-T/AMG1011-T using the web
configurator, select
Web
.
•
If you want to allow a user to connect to the AMG1001-T/AMG1011-T using Telnet,
select
Telnet
.
•
If you want to allow a user to upload firmware to the AMG1001-T/AMG1011-T, select
FTP
.
•
If you want to allow an administrator to send SNMP commands, select
SNMP
.
•
If you want to allow a user to find the AMG1001-T/AMG1011-T on the network (for
troubleshooting purposes, for example), select
Ping
.
•
Select
ALL
to allow access for all services. You cannot select a combination of services.
Interface
Select the port through which you can access the device. Select
Both
for access via either
port. If you configure 0.0.0.0 ~ 0.0.0.0
Secure IP Address
,
ALL
services and
WAN
interface, you will not be able to access the device at all from the LAN unless you
configure another rule for LAN access.
Access Control
Listing
The summary table displays the configured parameters for the selected rule.
Summary of Contents for AMG1001-T Series
