ZyXEL Communications AAM1212, User Manual

Page: 200 / 288

AAM1212 User’s Guide
Chapter 27 ADSL Commands 199
Figure 109 ADSL Show Command Example
27.3.2 ADSL Enable Command
Syntax:
adsl enable <portlist>
where
This command forcibly enables the specified ADSL port(s).
27.3.3 ADSL Disable Command
Syntax:
adsl disable <portlist>
where
This command forcibly disables the specified ADSL port(s).
Note: A port must be enabled before data transmission can occur. An enabled but
disconnected ADSL port generates more heat than an operating port. To
minimize heat generation and to enhance reliability, remember to disable a port
when it is not in use.
ras> adsl show 1
port enable mode up/downstream profile
---- ------ -------- ------------- -------------------------------
1 V auto 512/ 9088 max
Subscriber Info:
port name tel
---- -------------------------------- ----------------
1 - -
<portlist>
= You can specify a single ADSL port <1>, all ADSL ports <*>
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
<portlist>
= You can specify a single ADSL port <1>, all ADSL ports <*>
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.