Page 11
Operation (cont.)
The Pro-Palette will start a self-checking process when power is
applied. The unit will display the first DMX address of the 4COL
mode and is ready to use. For standard operation, connect the fixture
to a power source (100~240V AC single phase), and a DMX signal
cable. The LED Display will turn on after the power switch is turned to
the “ON” position and you are ready to set the desired configuration.
and DMX addresses.
Press the Function Knob once to enter the main menu. Rotate the
Function knob to change “Add- and SET- ”on the LED display.
Under the “Add-” menu, press the Function Knob to display (AX.X.X.)
on the interface, with three additional dots displayed under the value.
Rotate the Function knob to change the dimming address (dimming
address range: 1-512), and press the Function Knob once to save.
Under the “SET- ”menu, press the Function Knob to display any one of
4COL/HSI/FIL/CCT on the interface, rotate the Function Knob to select
one control mode, press the Function Knob again to save. The menu
will return to the main interface (Axxx) if there is no operation within 3
seconds.
Display of Numbers and Characters:
The four-bit seven-segment displays of MacoLEDs series LED light
fixtures adopt the following format to display the information:
Digits 0-9
Common Letters: A,B,C,D,E, and F
Special Letters: H,L,N,O,P,Q,R,S,T, and U.
Note: The number 5 and the character S have the same display format.
You can assign a starting DMX channel for the chosen mode, check out
the numbers of channels to be occupied by each mode in the chart in
page 12. These parameters can also be assigned through a console.
