Zylight Go-Panel, User Instructions

Page: 4 / 20

Page 3
Safety Precautions
• Use GFCI surge protectors whenever possible to protect your equipment against
voltage spikes and for your safety.
• Disconnect from main power before making any type of connections.
• To reduce the risk of electrical shock or fire, do not submerge this fixture in water.
• Do not attempt to operate this fixture if the power cord has been frayed or broken.
Do not attempt to remove or break off the ground prong from the electrical cord.
This prong is used to reduce the risk of electrical shock and fire in case of an
internal short.
• Do not remove the screws or front lens under any conditions. There are no user
serviceable parts inside.
• Never operate this fixture if the internal parts are exposed in any manner.
• Never plug the power supply unit or XLR connector directly into a dimmer pack.
DMX controls can only be used via the RJ45 connections.
• Do not attempt to operate this fixture if it becomes damaged.
• During long periods of non-use, disconnect the fixture’s main power.
• Always mount this fixture in safe and stable matter. Always use a safety cable as
part of a secure installation. This includes securing the barn doors with a safety
cable.
• Power-supply cords should be routed so that they are not likely to be walked on or
pinched by items placed upon or against them, paying particular attention to the
point they exit from the fixture.
• Heat: The fixture should be situated away from heat sources such as radiators,
heat registers, stoves, or other appliance (including amplifiers) that produce heat.
Direct exposure from tungsten halogen or metal halide discharge lamp sources
may also cause excessive heat and damage.
• Always be sure to mount this fixture in an area that will allow proper ventilation.
Allow at least 6” (15cm) between this device and a wall.
• Flammable Materials: Do not place your Go-Panel near combustible or volatile
solvents or gases to avoid the risk of fire.
• After use, make sure your Go-Panel is turned off. Power cords and or lithium ion
batteries should be disconnected.
Do not leave the lens pointed directly towards
the sun. The lenses will act as magnifying
glasses and damage the LEDs.
CALIFORNIA PROPOSITION 65 WARNING: These products can expose
you to chemicals including bisphenol A, which are known to the State of
California to cause cancer and birth defects or other reproductive harm. For
more information, go to www.P65Warnings.ca.gov.