Zylight Go-Panel, User Instructions

Page: 11 / 20

Page 10
DMX Termination:
The fixture has a built-in user-selectable DMX terminator. In
DMX mode, a brief tap on the intensity encoder toggles DMX termination ON or OFF.
If the fixture is at the end of the DMX chain the terminator should be turned ON. If the
fixture is in the middle of a DMX chain the terminator should be turned OFF.
-For a few seconds after toggling (or until a button is pressed), the screen will display
“DMX Termination: Now ON” or “Now OFF” based on the new setting.
-DMX termination is ON by default.
PLEASE NOTE: While in DMX Mode all other Go-Panel controls are disabled. To
restore dimming and ON/OFF control to the light, you must take the fixture out of
DMX Mode. To do this, simply press and hold the “MODE” button for 5 seconds and
the Go-Panel will go back to Manual Mode, giving the user local control of the fixture.
DMX Control Cont.
DMX 1
Channel Function Values
1 ON / OFF State
0 - 127: Light output is OFF.
128 - 255: Light output is ON.
2 Intensity
0: Light output is OFF.
1 - 255: Adjust output intensity. 1 is minimum
intensity and 255 is maximum intensity.
3 Color Temperature
0 - 255: Color temperature is adjusted in range
from a minimum of 3100K at 0 to a maximum of
6000K at 255.
4
Magenta / Green
Intensity
125 - 130: No Magenta or green output.
131 - 255: Adjust green output from a minimum
intensity at 129 to a maximum at 255. No
Magenta output.
124 - 0: Adjust Magenta output from a minimum
intensity at 127 to a maximum at 0.
5 Diffusion
0 - 255: Adjust diffusion. 0 represents minimum
diffusion while 255 represents maximum diffusion.
DMX Channel Assignments
The Go-Panel uses a total of five DMX slots. They are listed in order below:
Accessory Plate
for Ball Mount,
Battery Mount,
or Power Supply
Mount
Dimmer
Knob
Mode Knob
DC In
Friction
Hinge
RJ45 DMX In/Out,
USB Software Jack
Safety Cable Port