05
Use an 8 mm drill to drill 4 mounting holes on the wall with 99mm (H) x 38.3mm (W)
spacing. Each hole should be able to fit the M6*25mm anchor.
Push the 4 anchors into each mounting hole with a rubber hammer.
Knock out the necessary hole guard(s) and pass the network cable through.
Place the rear enclosure to the mounting holes, perfect the box position, and fix the
box with the KA4*25 mm screws. Then connect the network cable to the RJ45 connector.
If PoE cable is not used, please connect the power cable to the DC socket through
the net coil or the rear enclosure hole.
If there are any buttons, relays, and/or other devices that need to be used. Please
connect them to the phoenix terminal of the J2 connector through the net coil or the rear
enclosure hole.
Install the front panel onto the rear panel box and tighten with the M4*25mm screws
using a screwdriver.
1
2
3
4
5
6
7
Installation method -2
Hook Installation
3
1
2
4
Summary of Contents for SQ10
