9.0 HDBaseT RJ45 Pin Defined:
Video Link
(TIA/EIA-568-B
1. Orange-white
DATA 0 +
2. Orange
DATA 0 -
3. Green-white
DATA 1 +
4. Blue
DATA 2 +
5. Blue-white
DATA 2 -
6. Green
DATA 1 -
7. Brown-white
DATA 3 +
8. Brown
DATA 3 -
Caution:
1.
First time to use IR1 remote control or change new batteries you must set up IR ID.
2.
The wiring must be away from any equipment with electromagnetic wave, i.e.: microwave, mobile phone, radio equipment, high voltage, Fluorescent
light fixtures, power lines, etc.
3.
HDBaseT is not a regular network device. Do not connect with any networking equipment to avoid damage.
4.
IP Address, Subnet Mask, Gateway, DHCP Client, Media Type, MAC Filter setting made by MAHCL4X4V2 ETHERNET MENU.
5.
HDBaseT IR operation: Do not place IR emitter and receiver cable too close to avoid interference.
6.
HDBaseT RS232 under distribution mode: is not
able to send two devices simultaneously.
10. Web Control Function:
Initial IP Configuration
Setup MATRIX IP Address based on 4.7 ETHERNET section.
NOTE: If you set up as DHCP MAHCL4X4V2 Version up to (1.13 ) will note show the IP address. You will need to go into your router to confirm exact IP
address that was assigned or use our IP Finder.exe tool to know what IP was assigned by your router.
1.
Input IP Address on a web page, so you can link to the Web UI of the MATRIX host.
2.
Web UI Operation below:
Switch Settings:
POWER
Control MATRIX power on and standby