FV794 Rev. A 05/21/21
Page 3
B
B
B
Spout Installation - Step 1
Electronics Module Installation - Step 2
1.1. Carefully screw aerator into spout using included tool.
Take care to not pinch blue o-ring,it may help to wet the o-ring.
1.2. Install spout to sink using spout base gasket, plastic mounting
washer, star washer and mounting nut (and cover plate for versions
that are included).
1.3. Ensure that slot in plastic washer is facing forward.
2.1. Assemble the electronics module
2.1a. For non-IM assembly, connect hydrogenerator(A) downstream
of electronics module(B) and filter(C) to bottom of electronics
module.
Sensor cable should not pass through plastic mounting washer.
NOTE
: Before installation, turn off water supplies to existing faucet and remove faucet if replacing an existing device.
Clean the faucet basin and clear away debris. Flush all supply lines before connecting the faucet. Failure to do so
may result in debris clogging the inlets and/or internal control and mixing valve
1.2a. Z6955 version – secure two additional bolts using the
provided washers and nuts.
C
D
2.1b. For IM assembly, connect mixing yoke(A) and two filters(B) to
the electronics modules(C)(D).
Electronics module(C) should
be on hot line and electronics module (D) should be on cold
line.
A
A
C
