FV763 Rev. A 01/25/21
Page 5
Whilst modern plating techniques are used in manufacture of this product, the surface will be affected if cleaned incorrectly.
Surfaces should be maintained using a lean damp cloth, no abrasive agents or materials should be used or come into contact with the
surface finish, or this will invalidate your warranty
For further assistance with troubleshooting visit http://www.zurn.com
Problem
Possible Cause
Corrective Action
No water out
The battery is exhausted
(DC item)
Change the battery
Water supply cut off
Check water supply
Dirt in the filter
Clean the filter
Water pressure is too low
Raise the pressure
Water will not turn off
Dirt on the sensor window
Clear the dirt
Too little water flow
Water supply is turned too small
Adjust water supply
The filter is too dirty
Clean the filter
Water pressure is too low
Raise the pressure
Too much water flow
Water supply is turned too high
Adjust supply
Water pressure is too high
Adjust pressure
Short cycles of battery
Incorrect batteries
Change to 4 AA alkaline battery
The indicator light
is not on
The light is broken
Change the light or circuitry board
The circuitry board is wet or
signal line is wet
Dry out
The battery is exhausted
Change the battery
Poor connection of battery
Check the battery connection
Trouble-Shooting
Care & Maintenance
