Windshield Mounting Hardware
14. Remove paper backing to expose adhesive of four
supplied rubber washers and apply adhesive side to sur-
face of mounts as shown. Rubber washer should not over-
hang edge of mount.
15. Remove paper backing to expose adhesive of remain-
ing four rubber washers and apply adhesive side to the flat
side of the four finishing washers. Make sure rubber wash-
ers do not overhang edge of finishing washers.
16. Pass 10-32 Hex Socket Screws through the finishing
washers and loosely assemble with supplied rubber well-
nuts.
The flange of wellnut (10), should seat into recess of
rubber washer (12).
Install Windshield
17. Hold windscreen up to mounts. Starting at the lower
mounts, insert a screw assembly through windshield plas-
tic. Ensure that the wellnut end passes through the plas-
tic into the lower mount and that the rubber washer in the
screw assembly firmly seats against the windshield sur-
face.
18. Assemble remaining mounting hardware in the upper
mounts.
19. Adjust the windshield so that the air gap around the
windshield and headlight is even and the turn signals are
not touching the windshield.
Final Adjustments
20. Once the windshield is located correctly, firmly tighten
the 10-32 Hex Socket Screws so that the wellnuts are not
able to be pulled from the mounts.
Do not overtighten.
Make certain the M8 x 35 screws in Upper Mounts are
seated correctly before you fully tighten. (Screw may
bind during installation.) Final torque of M8 x 35
screw is 14 Nm (10 ft-lb).
21. Tighten the M8 x 35 socket head screws.
Check all remaining hardware for tightness
.
22. Check that the turnsignals have been correctly installed
and are operating correctly before riding motorcycle. Remove
the cover protecting the fender.
Note:
Note:
Installation Instructions: R 1150 R Windshield
Page 4
Rubber washer should not
overhang edge of mount.
Assembly of items 11 and 12.
Rubber washer(12) should not over-
hang edge of finishing washer (11).
Install screw assemblies at
the lower mount point first.
9
11
12
10
ZTechnik
PO Box 158 Maywood, IL 60153-0158 USA
708-343-0400 / Fax: 708-343-0625 / www.Z Technik.com / e mail: info@Z Technik.com
©2002 National Cycle, Inc.
Page 4 of 4
10-118516-000 Rev. B. 04/03
