17
•
AP Isolation
: When
Enabled
is selected, each of your wireless clients will not be able to communicate
with each other. Otherwise, the wireless communication via WLAN is available.
•
Frequency(Channel)
: Choose the appropriate channel to optimize the performance and coverage of
your wireless network.
•
The HT physical Mode parameters are shown below:
•
Channel Bandwidth
: Set the HT physical channel bandwidth.
•
Guard Interval
: Guard interval is to introduce immunity to propagation delays, echoes and reflections,
to which digital data is normally very sensitive.
•
Extension Channel
: Set extension channel. Extension channel is also able to send and receive data.
Click
Apply
to confirm your configuration.
Advanced
Select
Wi-Fi Setting > Advanced
, the advanced wireless network parameters are shown in the following
figure:
•
Beacon Interval
: The router broadcasts beacon message to announce that it has buffered frames to
deliver. The default value is 100 (ms).Beacons are packets sent by an access point to synchronize a
wireless network. Specify a beacon interval value. is recommended.
•
Data Beacon Rate(DTIM)
: A Delivery Traffic Indication Message(DTIM) informs next clients to listen
to broadcast and multicast messages.
•
Fragment Threshold
: This value should remain at its default value of 2346. If you experience a high
packet error rate, you may slightly increase your fragment threshold. Setting the fragment threshold too
low may result in poor performance.
•
Short Preamble
: The length of CRC block in the frames during the wireless communication.
Click
Apply
to confirm your configuration.
Security
Select
Wi-Fi Setting > Security
, the Security parameters are shown in the following figure:
