CDMA2000 1X EV-DO Wireless Data Terminal User Guide
ZTE Corporation
http
:
//www
.
zte
.
com
.
cn
1.
Introduction
Thank you for choosing AC8710 CDMA2000 1X EV-DO Wireless Data Terminal (hereinafter
referred to as Data Terminal) of ZTE Corporation.
The Data Terminal equips with a standard USB interface and supports both CDMA2000 1X
EV-DO and CDMA2000 1X network. In the area where there is signal, it allows you to go surfing
on the Internet, send
&
receive short messages, and make
&
receive phone calls.
2.
Precautions
¾
Please don’t use the product near flammable or explosive materials because it might cause
failure or fire.
¾
Keep the product away from high temperature, humidity, or dust because it might cause
failure.
¾
Avoid shock, cast or impact. Please keep the product well when you don’t use it.
¾
Do not unplug the antenna. Damage cause by misuse is not covered by this warranty.
¾
Don’t use the product near the place where is weak signal or high-precision electronic device
because the magnetic interference might cause the misoperation of electronic device or other
problems.
¾
Please make sure to quit the application before pulling out the terminal, otherwise it would
damage the terminal or affect the normal operation of the system.
¾
Please don’t insert or pull out the card with great force to avoid damaging the interface.
¾
This device has been tested for FCC RF exposure body SAR compliance with typical laptop
computers. In order to comply with FCC RF exposure requirements, AC8710 CDMA data
terminal user is recommended to have good knowledge on RF exposure. During operation,
a 1.5cm separation distance should be maintained between the antenna, whether extended or
retracted, and the user’s/bystander’s body (excluding hands, wrists, feet, and ankles) to
ensure FCC RF exposure compliance.
