03/12/2013
Z.R. Tool Inc. - MS31 Manual Sealless Combination Tool for Steel Strapping Operation Manual
www.zrtool.com/html/MS31Manual.html
2/7
Take tool with right hand and pull the
feedwheel lever towards the sealing
lever.
Insert both portions of the strap with left
hand into the sealing section.
Release the feedwheel lever and make
certain strapping is held by strap guide.
B
Hold tool firmly with left hand on the
sealing lever.
With right hand move the tension lever
forward and backward until the desired
tension is obtained.
C
Place right hand firmly on the tension
lever for supporting the tool.
With left hand push the sealing lever
forward until it reaches the stop.
D
Move the sealing lever back to its original
position.
To release the tool, with right hand pull
the feedwheel lever towards the sealing
lever, pushing the lever to the left, away
from the sealing section.
Top of page
MAINTENANCE
Clean the sealing section regularly with compressed air to remove any dust and particles.
Lubricate the die (position 16) and punch (position 25) daily with a thin grade of oil.
This will reduce friction and extend the life of the tool as well as the parts.
Spray the entire tool daily with a rust preventative, this will prevent any rust formation.
Top of page
ADJUSTMENTS
TO ADJUST SEALING DEPTH
Loosen nut (position 31), adjust hexagon socket set screw (position 44) with a hexagon key,
turn counterclockwise to increase sealing depth, or turn clockwise to decrease sealing depth,
retighten nut.
TO ADJUST CLEARANCE BETWEEN THE FEEDWHEEL (POSITION 5) AND GRIPPER
(POSITION 26)
