10
Intel
®
NM10-ITX series Motherboard
Installing Memory DIMMs
This motherboard accommodates two memory modules. It can support two 240-pin DDR2
800/667. The total memory capacity is 4 GB. You must install at least one module in any of the
two slots. Refer to the following recommendations to install the memory modules.
q
One DIMM
: Install it into slot 1 or 2. You can install the DIMM into any slot, however, slot 1
is preferred.
q
Two DIMMs
: Install them into slot 1 and slot 2
Refer to the following procedure to install the memory modules. Note that there is only one gap
near the center of the DIMM slot. This slot matches the slot on the memory DIMM to ensure the
component is installed properly.
1. Unlock a DIMM slot by pressing the module clips outward.
2. Align the memory module to the DIMM slot, and insert the module vertically into the DIMM
slot. The plastic clips at both sides of the DIMM slot automatically lock the DIMM into the
connector.
1
2
0
2
4
0
1
2
1
1
2
0
2
4
0
1
2
1
DDRII-1
DDRII-2
Summary of Contents for INTEL SERIES NM10-ITX-A-E Series
