Location
The appliance should be installed well away from sour-
ces of heat such as radiators, boilers, direct sunlight
etc. Ensure that air can circulate freely around the back
of the cabinet. To ensure best performance, if the ap-
pliance is positioned below an overhanging wall unit,
the minimum distance between the top of the cabinet
and the wall unit must be at least 100 mm . Ideally,
however, the appliance should not be positioned below
overhanging wall units. Accurate levelling is ensured
by one or more adjustable feet at the base of the cab-
inet.
If the cabinet is placed in a corner and the side with the
hinges facing the wall, the distance between the wall
and the cabinet must be at least 10 mm to allow the
door to open enough so that the shelves can be re-
moved.
Warning!
It must be
possible to discon-
nect the appliance from the
mains power supply; the
plug must therefore be
easily accessible after in-
stallation.
15 mm
15 mm
100 mm
A
B
Electrical connection
Before plugging in, ensure that the voltage and fre-
quency shown on the rating plate correspond to your
domestic power supply.
The appliance must be earthed. The power supply ca-
ble plug is provided with a contact for this purpose. If
the domestic power supply socket is not earthed, con-
nect the appliance to a separate earth in compliance
with current regulations, consulting a qualified electri-
cian.
The manufacturer declines all responsibility if the
above safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
Rear spacers
In the bag with the documentation, there are two
spacers which must be fitted as shown in the figure.
Slacken the screws and insert the spacer under the
screw head, then retighten the screws.
Door reversibility
Warning!
Before carrying out any operations,
remove the plug from the power socket.
Important!
To carry out the following operations, we
suggest that this be made with another person that will
keep a firm hold on the doors of the appliance during
the operations.
To change the opening direction of the door, do these
steps:
1. Remove the upper hinge taking care for the upper
door not to fall off and keep it for future actions.
2. Remove the up-
per door.
3.
Remove the up-
per support and
install it in the op-
posite side.
11
