2. Use supplied adhesive tape to mount the sensor to door / window frame and the magnet to
the moving part of your door / window.
NOTE: Make sure the orientation marks are facing each other and the gap between sensor
and magnet does NOT exceed 0.75”
when the device is in the closed position.
WARNING
- This product should be installed indoors upon completion of any building renovations
- Prior to installation, the device should be stored in a dry, dust-and-mold-proof place
- Do not install the Contact Sensor in a place with direct sun exposure, high temperature or
humidity
- Keep away from chemicals, water, and dust
- Ensure the device is never close to any heat source or open flame to prevent fire
- Ensure the device is connected to an electric power source that does not exceed the
maximum load power
- No part of the device may be replaced or repaired by the user, except for battery change
Z-WAVE PLUS CERTIFIED
This product can be included and operated in any Z-Wave network with other Z-Wave
certified devices from other manufacturers and/or other applications. All non-battery
operated nodes within the network will act as repeaters regardless of vendor to increase
reliability of the network.
WARRANTY
This Limited Warranty applies to physical goods, and only for physical goods, purchased from
Zooz (the "Physical Goods").
What does this limited warranty cover?
This Limited Warranty covers any defects in material or workmanship under normal use
according to instructions from the User Manual during the Warranty Period. Warranty
coverage applies to purchases made from authorized dealers only. See full list of Zooz
distributors here: getzooz.com/buy
During the Warranty Period, Zooz will repair or replace, at no charge, products or parts of a
product that prove defective because of improper material or workmanship, under normal
use and recommended maintenance. Zooz does not assume the cost of return shipping for
warranty service.
MAX 0.75”
