6
Align the protrusions then insert
Tighten the connection cover
●Controller Connection
●Adjust usage in skimmer
There are two ways to adjust the water level and
foam volume in the skimmer.
You can make the adjustment by using both method.
① Control Pipe
It is a variable valve that can adjust the amount of
drainage from 0 to 100%
.
(If it is set to 0%, water will overflow from the air outlet, so it can not be
actually set to 0%.)
Turn the pipe so that the water level inside the skimmer
stabilizes at the ideal water level. (See next page)
0％
100％
Turn clockwise to increase drainage and turn
counterclockwise to increase water level.
Do not turn it too much as it may cause
damage,
Attention
Be sure to have a "drip loop" between the outlet and the
controller.
"Drip loop" is mean that the part of the cord is below the location
of the outlet, as it can prevent water from running down the
cord and coming into connect with the outlet.
Attention
1.
Please connect the joint part of the pump and the controller with the following
connection method.
2.
Check that the main unit is under the water, so that the inside of the main unit
is filled with water before connecting the plug to the outlet.
※Please be careful that not to let the pump run idle, since it may cause damage to the pump.
Control Pipe
