2.
A.
FRONT MOTOR AXLES
The front motor axle is fitted with special
torque washers which ensure that the
wheel cannot spin in the dropout. It is
important to ensure that these washers
are locked in place before tightening. The
front motor nuts are spanner size 19 mm,
the torque rating is 35nm.
B.
REAR IGH GEAR AXLES
The rear wheel is fitted with a Shimano
Nexus 3 internal hub gear. You need to set
the tension of the chain before tightening
the axle nuts.
1.
WARNING!
Wheel axles are essential safety
elements on your bike. Please respect the
information below, otherwise you risk losing
parts and falling.
A WHEEL BADLY TIGHTENED OR BADLY
CENTERED CAN CAUSE ACCIDENTS AND
SERIOUS INJURY TO THE USER.
ATTENTION!
Les axes de roues sont des
éléments de sécurité indispensables sur votre
vélo. Veuillez respecter les informations
ci-dessous, sinon vous risquez de perdre des
pièces et de tomber.
UNE ROUE MAL SERREE OU MAL CENTREE
PEUT PROVOQUER DES ACCIDENTS ET DES
BLESSURES GRAVES A L'UTILISATEUR.
WHEEL AXLES AND TYRES
Figure 12: Locking torque washer
Figure 13: Tighten nut to 35nm
Set the chain tension by tightening
the axle tension bolts. M5 hex key.
The chain should have a slight
amount of flex in it, but not so much
flex that it adds tension to the
wheel spinning.
Once the tension is set you can
tighten the rear axle nuts. Note
you will need to remove the
Shimano Nexus shifter to tighten
the RH side wheel nut. This should
be set to 35nm.
Figure 14: Set axle tension by turning
bolt clockwise. Ensure the bolt on
the opposite side is also set
Figure 15: Tightening of axle nuts on the
chain side (right) and opposite side (left)
The Zoomo zero is fitted with puncture
resistant tyres, however it is always
recommended to keep pressure between
40 and 50 PSI to avoid pinch flats.
The tubes in the bike are schrader valves
so most pumps should work.
C. TYRE PRESSURE
10
Summary of Contents for Zero
Page 1: ...Zoomo Zero User Manual ...
