Effects
a
nd
Parameters
27
ZOOM GFX-8
SFX Effects
If one of the SFX effects below is set to ON in the DLY/REV module, the MOD module becomes inactive.
Common Parameters of SFX Effects
Adjusts the predelay time.
Adjusts the effect mix ratio.
Adjusts the picking detection sensitivity for
wah and the trigger sensitivity.
This is a sampler effect with up to 25 seconds of record/play time. For
details on operation, see the section "Using the Sampler" (see page 34).
Selects the recording source as follows.
PL:
Guitar signal from INPUT jack
AU:
Stereo line signal from AUX IN jack
HINT:
When PL is selected, the signal is recorded after passing
the EQ module. When AU is selected, the signal is
recorded without passing any effect modules.
This parameter determines whether pitch compensation is
performed when playback speed is changed. Available settings
are "on" (compensation on) and "oF" (compensation off).
Selects the playback speed.
When pitch compensation was not selected with the PITCH
parameter, the pitch of the playback sound changes as follows
according to the SPEED parameter.
Adjusts the playback tone. Settings from -10 to -1 mean a low-
range cut and settings from 1 to 10 a high- range cut.
NOTE:
While the sampler function is used, the expression pedal
always operates as volume pedal for the input/playback
signal. Therefore the SAMPLER effect does not have an
RTM parameter.
Switches the sampler function on and off.
This is a combination effect of auto-wah and tremolo.
Adjusts the auto-wah sensitivity. When set to a negative value,
the wah effect operates in the downward direction.
Adjusts the time lag between the input signal and the start of the
tremolo effect. When the setting is "oF", the effect is always
operating.
Adjusts the tremolo effect depth.
Adjusts the tremolo modulation rate.
See
TYPE 1A (REV HALL)
.
Parameter 8
Parameter 5
1 - 50
TRM RATE
Parameter 4
0 - 50
TRM DPT
Parameter 3
oF, 1 - 50
RISETIME
Parameter 2
-10 - -1, oF, 1 - 10
AWA SNS
Parameter 1
AWA+TRM
8A
TYPE
10 - 0 - 10
TONE
Parameter 4
1.0
94
89
84
79
75
71
67
50
25
SPEED Parameter
value
Original pitch
1 octave down
2 octaves down
1 semitone down -
7 semitones down
Playback pitch
1.0, 94, 89, 84, 79, 75, 71, 67, 50, 25
SPEED
Parameter 3
oF, on
PITCH
Parameter 2
PL, AU
SOURCE
Parameter 1
SAMPLER
7B
TYPE
SENS
xx MIX
PRE DLY
[CONTROL SW]
indicates an
item that can be operated with
the CONTROL switch (see page
31).
Indicates a parameter
that can be controlled by
RTM( see page 30).
Indicates a parameter that can
be controlled with the PARM
VALUE knob during easy edit
(see page 11).
• nM (Normal)
Playback in normal direction.
• rS (Reverse)
Performs playback in the reverse direction.
• SC (Scratch)
The playback direction changes according to the movement of
the expression pedal. Pushing the expression pedal from about
the center position down causes normal playback, and moving
the pedal in the opposite direction causes reverse playback.
Selects the playback mode for foot switch 2.
• tS (Trigger one-shot)
Pressing foot switch 2 causes one-time playback from the
beginning, according to the setting of parameter 1. Pressing
foot switch 2 during playback stops play.
• tL (Trigger loop)
Pressing foot switch 2 causes loop playback from the
beginning, according to the setting of parameter 1. Pressing
foot switch 2 during playback stops play.
• GS (Gate one-shot)
While foot switch 2 is depressed, the unit performs one-time
playback from the beginning, according to the setting of
parameter 1. Releasing foot switch 2 during playback stops
play.
• GL (Gate loop)
While foot switch 2 is depressed, the unit performs loop
playback from the beginning, according to the setting of
parameter 1. Releasing foot switch 2 during playback stops
play.
• rS (Retrigger one-shot)
Pressing foot switch 2 causes one-time playback from the
beginning, according to the setting of parameter 1. Pressing
foot switch 2 during playback restarts play.
NOTE:
The JAM PLAY effect does not have an RTM parameter.
Switches the jam play function on and off.
0 - 50
MIX
Parameter 3
tS, tL, GS, GL, rS
TRG/GATE
Parameter 2
