- 12 -
Special function start up
1. Special function and how to start up
There are some methods to start up the G1X for service.
All special functions start
up the G1X in the following ways using the AC adaptor AD-0006 or
connecting the plug into INPUT connector (J2) when set the battery.
Turn on the G1X holding the key in the following table.
See the following table about Special function.
Function
Keys held down
Test mode
BANK UP
・
TAP
16 click adjust
STORE + RHYTHM
Back up user’s data
STORE + BANK UP
・
TAP
ALL
Initialization
STORE
Pedal calibration
PEDAL ASSIGN
Pre-select
UP ([^])
Revision
DOWN ([v])
Version
BANK UP
・
TAP + UP([^])
2
．
Details of special function
●
Test mode
This startup is used for the function Test.
Refer to page
4.
●
16 click adjust
Adjust the threshold of 16 click vol. (from 0 click to 15 click)
1) Start up holding the [STORE] key (SW3) and [RHYTHM] key (SW2).
Make sure “1” appears on the 7 segment LED.
2) Turn the Module selector (VR1) clockwise by one detent.
Press the [STORE] key (SW3).
*
Refer to the figure below.
Make sure “2” appears on the 7 segment LED.
3) Turn the Module selector (VR1) clockwise by one detent.
Press the [STORE] key (SW3).
Repeat this sequence to “DECAY”.
(When “PATCH LEVEL”, 7 segment LED is displayed “3”.
When “COMP/EFX”, 7 segment LED is displayed “4”.
.
.
.
When “REVERB”, press the [STORE] key (SW3), 7 segment LED is displayed “15”.)
Make sure “-14” appears on the 7 segment LED.
4) Turn the Module selector (VR1) anticlockwise by one detent.
Press the [STORE] key (SW3).
Make sure “-13” appears on the 7 segment LED.
