47
ZOOM B9.1ut
MIDI Usage Examples
To enable the B9.1ut to receive
2.
control change messages, turn the
[TYPE] knob to bring up the "MIDI
CTRL Rx" (receive control change)
parameter, and turn parameter
knob 1 to select the "ON" setting.
40+0
*;939_$65l
Parameter knob 1
To enable the B9.1ut to send
3.
control change messages, turn the
[TYPE] knob to bring up the "MIDI
CTRL Tx" (send control change)
parameter, and turn parameter
knob 1 to select the "ON" setting.
40+0
*;93;_$65l
Parameter knob 1
When the setting is complete,
4.
press the [EXIT] key to cancel the
SYSTEM menu.
I f a set t i ng was cha nge d, t he i nd icat ion
"Store...?" appears on the display, to allow you
to store the changes.
If no setting was changed, the unit returns to the
previous mode.
:[VYL&
@B:;69,D5B,?0;D
Press the [STORE/SWAP] key to
5.
save the changes.
The setting is accepted, and the unit returns to
manual mode or play mode. By pressing the
[EXIT] key, you can abort the changes and
return to play mode without saving.
■
Assigning control change numbers
You can assign control change numbers to
the expression pedal and keys of the B9.1ut as
follows.
NOTE
Before carrying out the following steps, verify
that the send/receive MIDI channel setting of
the B9.1ut is as required (
→
p. 42), and that
send/receive of control change messages is
enabled (
→
p. 46).
In manual mode or play mode,
1.
press the [SYSTEM] key.
70*2<7:LS
(*;0=,
Turn the [TYPE] knob to bring up
2.
the display for assigning a control
change number.
Operations to which a control change number
can be assigned are listed in the table on the
next page.
For example, to assign the control change
number 11 (cc#11) to the vertical direction of the
built-in expression pedal, the following display
is used.
40+0JJ
7,+(3=$
[TYPE] knob
HINT
The control change number assignment always
applies both for sending and receiving.
Turn parameter knob 1 to specify a
3.
control change number.
40+0JJ
7,+(3=$l
Parameter knob 1
0804B9E.indb 47
0804B9E.indb 47
08.4.25 10:58:37 AM
08.4.25 10:58:37 AM
