36
ZOOM B9.1ut
Making settings for
function foot switches
The function foot switches 1 – 3 can be used to
perform user-assigned functions. To assign a
function to a switch, proceed as follows.
In manual mode or play mode,
1.
select the patch.
HINT
Functions assigned to the function foot switches
1 – 3 are speci
fi
c to each patch.
Press the [FOOT SW] key.
2.
The display changes as follows.
-\UJ:>(ZZPNU
)`WZ!)`WHZ6U6MM
HINT
The function foot switch setting is included in
the TOTAL/FUNCTION module for the patch.
The above display can also be called up by
pressing the [TOTAL/FUNCTION] key in the
effect module key section and then turning the
[TYPE] knob.
Use the parameter knobs 1 – 3 to
3.
select the function for function
foot switches 1 – 3.
The parameter knob number corresponds to the
function foot switch number.
For example, when you turn parameter knob 2,
the display changes as follows.
-\UJ:>(ZZPNUl
w4\[L!4\[L6U6MM
Function assigned to function
foot switch 2
■
When parameter knob 2 is turned
The following functions can be assigned to
function foot switches 1 – 3.
●
BypasOnOff, Mute OnOff
The function foot switch toggles the bypass
mode and mute mode between on and off. In
either mode, the tuning display appears.
●
ManualMode
The function foot switch toggles between play
mode and manual mode.
●
BPM TAP
The function foot switch can be used to
specify the individual tempo for a patch (
→
p. 38). When the switch is pressed repeatedly,
the interval between the last four presses is
detected and averaged automatically, and the
result is used the new tempo setting.
HINT
Using the tempo set here, speci
fi
c parameters
(Time and Rate) can be synchronized in note
units (
→
p. 38).
●
Delay Tap
The function foot switch can be used to
specify the Time parameter for the DELAY
module.
HINT
• While BPM TAP speci
fi
es the tempo for an
individual patch, Delay TAP uses the foot
switch operation interval to directly set the
This section explains how to assign individual functions to the function foot switches 1 – 3 and how to
select the modules that are assigned to the foot switches 1 – 4 in manual mode.
Using the Foot Switches
0804B9E.indb 36
0804B9E.indb 36
08.4.25 10:58:12 AM
08.4.25 10:58:12 AM
