ZOODOS 89470, Instruction Manual

Page: 67 / 113

67
NO
SE
FI
GB
DE
DK
PL
ET
Retighten the blade lock.
Loosen the two hexagonal screws by the
clamp for the cleaver blade using the Allen
key.
Position the cleaver blade (F) down
between the clamp’s two metal plates and
adjust its position.
The distance between the cleaver blade and
the saw blade teeth must be at least 5 mm
and must be identical to the curve of the
saw blade.
The tip of the cleaver blade must be no
more than 5 mm lower than the saw blade
teeth for the sawing depth set.
Tighten the two hexagonal screws so that
the cleaver blade is secure.
Replace the insert into the bench and screw
tight.
Screw the blade guard (E) securely to the
cleaver blade using a screw and a nut.
Screw the holders securely to the push stick
on the left side of the saw.
Settings
Setting the saw depth
Undo the blade lock.
Turn the hand wheel to raise or lower the
saw blade. The saw blade should protrude
no more than 3 mm over the upper surface
of the item. Remember to adjust the cleaver
blade correspondingly.
Retighten the blade lock.
Adjusting the parallel guide
Use the parallel guide (1) when you make a
cut along the item.
Push the parallel guide into the groove on
the workbench on the left and right side of
the blade. The rail of the parallel guide can
lie flat or stand upright on the workbench.
Loosen the lock knob (3) for the parallel
guide and push it to the required position.
Retighten the lock knob.