©2017 ZOO FANS INC. ALL RIGHTS RESERVED
1650 38
th
St, Suite 201W Boulder, CO 80301 PHONE: 303-557-1852
zoofans.com
REV 05182017
INSTALLATION
HANGING THE FAN
The fan intake must be 12” from any obstruction.
ZOO Fans are designed to be hung vertically or at an angle. For vertical installations, proceed to STEP 1 below.
To install the ZOO Fan at an angle
, additional hardware is required. Please contact ZOO Fans or your ZOO Fans’
representative.
STEP 1: Fasten Main Hanging Cable
Use the hardware from
the white bag labeled “Bag 1 of 2” containing the 8’ Cable with 3/8”
Stud End Fixing, and
attach that cable to the hole at the top of the
fan’s
handle as shown in
, below.
NOTE: Gripple Installation Guidelines are included with your Gripple hardware and should be consulted for
information about installing, adjusting and caring for your Gripple attachment hardware.
TIP
: When attaching these cables, leave the cables wound, as shipped, until you are ready to hang the fan.
1.
Place 3/8”
Nut on Stud Fixing
2.
Place 3/8” Flat Washer on Stud Fixing
3.
Insert 3/8
”
Stud Fixing through the center hole in the handle
4.
Place 3/8
”
Flat Washer, 3/8
”
Lock Washer, and 3/8
”
Nylock Nut on thread sticking through the handle
5.
Securely tighten 3/8
”
Nylock Nut
Illustration 1
