7
F: Display the remaining time for ice making in a cycle (in minutes).
Display the set time when presetting the start/end time of ice making (in hours).
G: Timing & Cleaning button:
–
During Ice maker working, press this button to preset end time of the ice making (in
hours). Press this button again to cancel the setting.
–
In standby mode, press this button to preset the ice making start time (in hours).
Press this button again to cancel the setting.
–
In standby mode, press this button for 3 seconds, unit will skip to “cleaning” mode.
● How to start using your ice maker
1. Plug in power and press the On/Off button, the ice maker will automatically run the power
on cleaning program first and the “cleaning” light on, then ice making process will
automatically started after the cleaning completed, and “ice making” light on.
2. When the ice cubes reach the set thickness, it will fall into the ice bucket automatically.
Then the ice maker proceeds to the next ice making process automatically.
3. The ice maker will stop ice making automatically when the ice bucket is full with ice cubes
and the “Ice full” light is on. When the proper ice cubs are removed, the ice maker will
continue the ice making process.
Remark:
The ice making cycle lasts about 20 to 25 minutes, depending on the ambient
temperature. And for the first time, according to the initial water temperature, ice-making last
time will be a little longer. In the extreme hot room temperature, ice-making time maybe vary
a lot.
● How to adjust Ice thickness
1, If you think the ice cubes are not thick enough, during ice maker working, press "+" button
for 3 seconds to enter the mode of adjusting the ice thickness, and the display flashes. Then
change the ice thickness by using "+" and "-" to change the lead time of ice making basis on
the current lead time. The maximum increase is 25 minutes. The minimum reduction is - 9
minutes.
2, The new setting of ice thickness can only start from the new cycle.
●
Turn on/Off the light in the ice bucket
Press "-" key for 3 seconds to turn on the light, and press "-" for 3 seconds to turn it off when
light is on.