Automated External Defibrillator Trainer
Operator's Guide
For replacement parts, see the AED PLUS Administrator's Guide.
NOTE
1.
Keep the unit clean, undamaged, and free of excessive wear.
2.
Verify that there are no cracks or loose parts in the housing.
3.
Verify that all cables are free of cracks, cuts, and exposed or broken
wires.
4.
Replace Training electrodes as necessary.
MAINTENANCE
Insert six new "C" batteries into the battery well in the Trainer. Replace
batteries before expiration date, if the unit fails to power on, or if the unit returns
to "Select Mode" during voice prompts.
Alternatively, you can power the unit using the supplied AC adapter.
POWER
The Trainer does not respond
when you press .
Check and replace batteries. If the unit
still does not respond, call Zoll Technical
Service.
CHECKSUM ERROR
Call Zoll Technical Service.
PROCESSOR ERR
Call Zoll Technical Service.
AED Trainer problem / display:
Action:
TROUBLESHOOTING
To increase the prompt volume, insert a small flat blade screwdriver into the slotted
opening on the right side of the unit and turn clockwise.
VOLUME CONTROL
Clean unit with soft, damp cloth using 90% isopropyl alcohol, or soap
and water, or chlorine bleach (30 ml/liter water).
Do not immerse any part of the unit in water.
Do not use ketones (e.g., MEK, acetone).
Avoid using abrasives (e.g., paper towels) on the displays.
Do not sterilize the unit.
CLEANING
© ZOLL Medical Corporation 2006
TRAINING USE ONLY - NOT FOR CLINICAL USE
REF
9650-0304-01 Rev. E
Metronome On/Off
This control activates the training unit's metronome which begins
to beep at 60 compressions per minute (CPM) then automatically
accelerates to 100 CPM after a few seconds. Metronome beeps
are independent of the student's actual compression rate and
continue until the CPR period times out or until the Metronome
On/Off key is pressed again. The control and the metronome
function are only active during periods when the AED Trainer has
prompted the rescuer to perform CPR.
Push Harder Control
Pressing this control button causes the training unit to emit a
single "Push Harder" voice and text prompt. Instructors should
depress this button when the student's chest compressions are
too shallow.
Note:
The AED PLUS will issue only two "Push Harder" prompts
during each CPR session when chest compressions are less than
1 ½ inches (3.75 cm) deep.
Good Compressions Control
Pressing this control button causes the training unit to emit a
"Good Compressions" voice prompt and text message. To
simulate operation of the AED PLUS defibrillator, instructors
should use this control to provide students with positive feedback
about improvements in chest compression depth when they
respond to "Push Harder" prompts.
Note:
The AED PLUS emits a maximum of one "Good
Compressions" prompt during each CPR session.
Handheld control:
Description:
CPR FEEDBACK OPERATION
The AED PLUS Trainer includes controls that allow instructors to simulate the voice prompts
and text messages issued by the AED PLUS when rescuers perform CPR. These controls
include:
Product intended for indoor use only.
WARNING
This device is for training use only. It will NOT deliver
defibrillation energy.
WARNING
Use only Safety Agency-approved AC/DC or DC/DC power
adapter rated 12 VDC at 800 mA output.
WARNING
OK
International Service: Contact your local distributor.
ZOLL Medical Corporation
269 Mill Road
Chelmsford, MA USA 01824-4105
978-421-9655 800-348-9011
Fax: 978-421-0010
For technical support or repair:
Technical Service Department
Trainer
