ClearVu/Encore Dispenser (9330/9331)
Assembly & Operation Instructions
1. Thoroughly clean wall surface and let dry completely. For silicone
build-up, use a pumice-type cleaner or grout cleaner to clean the
surface.
2. Peel off paper from back of tape (supplied). Press dispenser firmly to
the wall and hold for at least 30 seconds to make sure tape has
completely adhered to the wall. (Figure 3)
3. Wait 24 hours before filling with soap to ensure that the tape has
completely adhered to the wall before adding weight.
1. Remove lid. Push latch out and detach dispenser from backplate. (Figure 4)
2. Using the backplate as a template, mark hole locations on wall.
3. Drill 3/16” diameter holes for anchors and screws or other hardware.
Attach dispenser to backplate and replace lid.
• Use included tape on glazed tile, painted metal, or unpainted metal
walls. Tape should not be used on porous surfaces like brick or wood.
• On all other wall surfaces, use screws and anchors (not included) or
other appropriate hardware based on surface type.
• Locate dispenser above a sink or counter. We recommend you never
locate the dispenser where spillage can fall on the floor, creating a
hazardous condition.
• Installer will be held responsible for proper installation.
• To be in compliance with ADA regulations, the dispenser should be
mounted no more than 48” from the ground.
Questions? We’ve got answers!
888.623.0088 • [email protected]
Mounting with tape
Mounting with screws and anchors
Mounting Instructions
Page 2 of 2
