8
SPIN
™
CONTROLLER FUNCTIONS
There are two buttons on the front of the controller.
Silence/Reset
• Can be pressed to silence current alarms for 24 hours.
•
Can be held for longer than 3 seconds to reset alarm. Reset will clear flashing light on unit.
Test
• Will run the pump to determine if amp draw of pump is in range.
• Controller is factory programmed to self-test the pump for several seconds every 24 hours.
• Pressing the test button will start the 24-hour timer for self-testing.
Note: Holding both the silence/reset and test button at the same time for 5 seconds will cause a factory reset on the controller.
AQUANOT
®
SPIN
™
Solid
Flashing
Off
System Ready
No Faults (Green)
AC off with no faults
(Green)
--
Battery
Charged (Green)
Low Battery (Red)
No AC Power
Charging (Yellow)
Bad Battery (Red)
DC pump
Pump Ran (Yellow)
Pump Running (Yellow)
--
Pump Fault (Red)
Float Status
*High Water (Red)
sensor activated
Float Fault (Red)
--
© Copyright 2020 Zoeller
®
Co. All rights reserved.
The LEDs will display information about the controller.
There are millions of batteries manufactured each year, so it is impossible to guarantee consistent quality. A defective battery will never
become fully charged and may damage the charging circuits of the Control. It is for this reason that Zoeller Pump Company offers its own
line of batteries. We offer both a water/acid deep-cycle battery and a maintenance-free AGM battery which can run the pump continuously
for over 5 hours. These times are based on continuous pumping at 8' (2.4 m) of static head. Actual times will vary depending on static
head, volume of water entering the pit, and the condition of the battery.
Follow these recommendations:
• Use a B.C.I. size 27 deep-cycle battery, 175 minute reserve capacity, or larger
• Do NOT use a “maintenance-free” battery unless it is an AGM battery
• Replace your battery every 3 years
• Do not let corrosion build up on the battery terminals
• To check specific gravity, follow the instructions on a hydrometer (wet cell batteries only)
• Use of the included plastic battery box is recommended to keep the battery safe and clean.
PROTECT YOUR WARRANTY:
• Water level in batteries must be checked once a month (wet cell batteries only)
THE AQUANOT
®
BATTERY
CARBON MONOXIDE DETECTORS
Whether you have an Aquanot
®
Backup Pump System or a competitive brand, all use batteries that give off gaseous by-products when charging.
Some of these by-products can produce a rotten egg odor. Also, some of these by-products can cause a CO detector to falsely activate. In
order to help prevent false activation, Zoeller Pump Company recommends moving the battery as far away from the CO detector as possible
or, if necessary, vent the battery to the exterior. Zoeller Pump Company provides the previous statements only as guidelines to help prevent
false activation of the CO detector. In no way are they meant to supersede the instructions that accompany the detector, nor do they supersede
advice from the CO detector manufacturer.
If the audible alarm associated with your CO detector is activated, we recommend the following actions:
1) Take immediate action for personal safety as recommended in the CO detector literature.
2) Contact the appropriate agency to determine if the CO is being produced by your furnace, water heater, or any other device which uses
natural gas.
3) If you are certain that no CO is being produced, a charging battery may be producing gaseous by-products which are causing the CO detector
to activate. Contact the manufacturer and ask for recommendations to prevent the alarm activation.
* If optional high water reed sensor is being used.
