background image

12

© 2020. All rights reserved.

13

© 2020. All rights reserved.

Problem

Possible Cause

Corrective Action

Pump operates, 

but delivers little 

or no water.

1.  Low line voltage.

1.  Contact an electrician.

2. Inlet screen clogged.

2. Remove debris.

3.  Broken impeller or debris in impeller 

cavity.

3.  Remove screen and volute, clean 

impeller or replace impeller.

4.  Check valve stuck closed or installed 

backwards.

4.  Be sure check valve is installed and 

operating properly. Replace check 

valve if necessary .

5.  Shut off valve closed.

5.  Open shut off valve.

TROUBLESHOOTING

CARE AND MAINTENANCE

  

WARNING:  

Always disconnect pump from power 

supply before handling.

Inspect and test system for proper operation at least every 

three months.

1.  Remove any build-up of debris from the switch or float, 

and check to be sure it moves freely.

1

2

2.  Remove any debris from the basin that could interfere 

with the operation of the switch.

WARRANTY

This product is warranted for three years from the date of purchase. Subject to the conditions 

hereinafter set forth, the manufacturer will repair or replace to the original consumer, any portion of 

the product which proves defective due to defective materials or workmanship. To obtain warranty 

service, contact the dealer from whom the product was purchased. The manufacturer retains the sole 

right and option to determine whether to repair or replace defective equipment, parts or components. 

Damage due to conditions beyond the control of the manufacturer is not covered by this warranty.

THIS WARRANTY WILL NOT APPLY: (a) To defects or malfunctions resulting from failure to properly 

install, operate or maintain the unit in accordance with printed instructions provided; (b) to failures 

resulting from abuse, accident or negligence or use of inappropriate chemicals or additives in the 

water; (c) to normal maintenance services and the parts used in connection with such service; (d) 

to units which are not installed in accordance with normal applicable local codes, ordinances and 

good trade practices; and (e) if the unit is used for purposes other than for what it was designed and 

manufactured.
RETURN OF WARRANTED COMPONENTS: Any item to be repaired or replaced under this warranty 

must be returned to the manufacturer at Kendallville, Indiana or such other place as the manufacturer 

may designate, freight prepaid.

THE WARRANTY PROVIDED HEREIN IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES, 

AND MAY NOT BE EXTENDED OR MODIFIED BY ANYONE. ANY IMPLIED WARRANTIES SHALL 

BE LIMITED TO THE PERIOD OF THE LIMITED WARRANTY AND THEREAFTER ALL SUCH 

IMPLIED WARRANTIES ARE DISCLAIMED AND EXCLUDED. THE MANUFACTURER SHALL 

NOT, UNDER ANY CIRCUMSTANCES, BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR 

SPECIAL DAMAGES, SUCH AS, BUT NOT LIMITED TO DAMAGE TO, OR LOSS OF, OTHER 

PROPERTY OR EQUIPMENT, LOSS OF PROFITS, INCONVENIENCE, OR OTHER INCIDENTAL 

OR CONSEQUENTIAL DAMAGES OF ANY TYPE OR NATURE. THE LIABILITY OF THE 

MANUFACTURER SHALL NOT EXCEED THE PRICE OF THE PRODUCT UPON WHICH SUCH 

LIABILITY IS BASED.
This warranty gives you specific legal rights, and you may have other rights which vary from state to 

state. Some states do not allow limitations on duration of implied warranties or exclusion of incidental 

or consequential damages, so the above limitations may not apply to you.

In those instances where damages are incurred as a result of an alleged pump failure, the 

Homeowner must retain possession of the pump for investigation purposes.

Summary of Contents for 1263










Reviews: